Radio Interview with Jeff Rense on January 15, 2018

The Curved Stone at Abu Rawash

View from the top of the Abu Rawash pyramid

The compound curved granite stone

Photographing and measuring the stone

Chris Dunn checks the surface of the stone while David Childress looks on

Obvious curve to stone is revealed by straight edge

Macro image of the surface of the stone showing the striations of the saw

Determining the surface radius using the cord length and sagitta (cord height). The calculations indicate a radius of 23.95ft

Determining the radius where cutting ended. The calculations indicate a radius of 23.68ft

	Top View (X & Y-Axes)		End View (Z-axis)
	Feet/Rad/Deg	Meters	Feet/Rad/Deg	Meters
Cutter Diameter	37.5	11.43	37.5	11.43
Radius Measured	23.684	7.22	23.95	7.30
Radian Measure	.792		.782
Tilt Angle of Cutter	45.4		44.8

Calculations to determine the diameter of a cutter that when tilted will create both radio

View looking down showing block radius with 37.5 feet diameter saw in a horizontal position

When tilted on a 45 degree angle, a vertical view of the saw shows it to be an ellipse. It is a small section of the ellipse that will produce two large radii. One on the x – y axis (vertical view) and also on the x – z axis (horizontal view along the y axis).

More information on this technique may be found at the following link: large radius

Using calculations to select cutter to create 1/61 scale model in micarta

Mental gymnastics on paper trying to address anomolies

Referred to as a boat pit, this trench answers the question of how they would mount a 37 ft diameter saw

Mega Machines for Mega Builders

Also labeled as boat pits, numerous trenches are found on the Giza Plateau

Saw mounted in one of the trenches

A view of the plateau at sunset

The genius that went into the concept and design of the pyramids was not limited when it came to designing the tools to accomplish the job. Time to give the pyramid builders credit for their true accomplishments, seen and not seen (implied)